Selectează o Pagină

Vana de inchidere din PE-HD

AKHP

Robinet cu bila din PE-HD pentru perforare sub presiune

Tapping Ball Valves in HD-PE, 1/4 turn, for side tapping under pressure
Compact tapping ball valve in HD-PE. Factory made combination of FRIALEN Saddle Moulding and FRIALEN Ball Valve with spigot for space and cost saving horizontal installation especially for integration of branches into mains under operating pressure. Leakage and swarf free tapping up to 10 bar (gas) and standard tapping equipment (we recommend Hütz & Baumgarten (www.huetz-baumgarten.de)). With exposed heating element for optimal heat transfer.

PE 100 SDR 11

Maximum working pressure 10 bar (gas)

SKU d1 d2 BX PU L t sw1 sw2 H Drilling
Ø da
Weight kg
615427 110 63 6 48 330 110 50 x 50 25 180 42 3,070
615428 110 90 4 32 335 90 50 x 50 25 240 60 4,670
615431 125 90 4 32 335 90 50 x 50 25 240 60 4,790
615433 160 63 4 32 330 110 50 x 50 25 180 42 3,300
615434 160 90 4 32 335 90 50 x 50 25 240 60 5,000
615437 180 90 4 32 335 90 50 x 50 25 240 60 5,000
615440 225 90 4 32 335 90 50 x 50 25 240 60 5,000

FRIALEN-Tapping Ball Valves can be used for pipes of SDR stages 11 to 17.6. DVGW-Registration Nos. AKHP: DG-8631AU2252 and DG-8631AU2253

For tapping of pipes under pressure we recommend tapping equipment of Hütz + Baumgarten.

Areas of Application

The FRIALEN-Tapping Ball Valve, completely made from HD-PE, makes it possible to tap sideways into an operational HD-PE mains under gas and water pressure (no drinking water!) – without any escape of gas or water.

Assembly Instructions

The fusion of FRIALEN Tapping Ball Valves to the HD-PE main takes place by FRIALEN fusing – leakproof and longitudinally strong. The pipe and the saddle have to be prepared (oxide layer removal/cleaning) in accordance with the general installation instructions (see „Assembly Instructions“ for FRIALEN Safety Fittings for house connections and distribution pipes up to d 225).

Tapping of the HD-PE pipe under operating pressure

For this we recommend the tapping equipment of Hütz + Baumgarten. It is clamped onto the exposed fusion end of the ball valve. The tapping of the HD-PE pipe takes place through the opened ball valve and is leakage free.

Actuating the shut-off valve

By the telescopic actuating installation kit KBS from the valve cover.

Good reasons for using the FRIALEN-Tapping Ball Valves:

  • Fusioning and tapping under pressure saves time-consuming and expensive shut-offs and emergency supply during the integration
  • Installation of mains and service lines takes place on one level and thus affords advantages in the planning stages
  • Construction and connecting works are reduced to a minimum
  • The ball valve can be used as a shut-off device afterwards
  • Additional barcode for tracing back the underground fitting (Traceability-Coding)